Troubleshooting - Troy-Bilt FLEX Manual Del Operador

Troubleshooting

Problem
Excessive vibration or noise when
the Attachment Control Lever is
applied.
Augers continue to rotate
Unit fails to discharge snow
12
Cause
1. One or more of the clutch bumpers is missing or worn.
2. Loose parts or damaged auger.
1. Cable out of adjustment.
1. Chute assembly clogged.
2. Shear pin(s) sheared.
3. Foreign object lodged in auger.
4. Auger control cable out of adjustment.
5. Auger belt loose or damaged.
Remedy
1. Replace the three clutch bumpers with replacement kit
part no. 753-08457.
2. Stop engine immediately and disconnect spark plug
wire. Check for possible damage. Tighten all bolts and
nuts. Repair as needed. If the problem persists, take unit
to an authorized service dealer.
1. Adjust the auger control cable as shown in the
Maintenance Section under "Adjusting the Auger Drive
Cable".
1. Stop engine and disconnect spark plug wire. Clean
chute and inside of auger housing with clean-out tool
or stick.
2. Replace shear pin(s).
3. Stop engine immediately and disconnect the spark plug
wire. Remove object from auger.
4. Adjust auger control cable.
5. Replace auger belt.
6