Troubleshooting - Troy-Bilt FLEX 23AABA6X711 Manual Del Usuario

Troubleshooting

Problem
Excessive vibration or noise
when the Attachment
Control Lever is applied.
Augers continue to rotate
Unit fails to discharge snow
Cause
1. One or more of the clutch bumpers is missing
or worn.
2. Loose parts or damaged auger.
1. Cable out of adjustment.
1. Chute assembly clogged.
2. Shear pin(s) sheared.
3. Foreign object lodged in auger.
4. Auger control cable out of adjustment.
5. Auger belt loose or damaged.
Remedy
1. Replace the three clutch bumpers with
replacement kit part no. 753-08457.
2. Stop engine immediately and disconnect
spark plug wire. Check for possible damage.
Tighten all bolts and nuts. Repair as needed.
If the problem persists, take unit to an
authorized service dealer.
1. Adjust the auger control cable as shown in
the Maintenance Section under "Adjusting
the Auger Drive Cable".
1. Stop engine and disconnect spark plug wire.
Clean chute and inside of auger housing with
clean-out tool or stick.
2. Replace shear pin(s).
3. Stop engine immediately and disconnect the
spark plug wire. Remove object from auger.
4. Adjust auger control cable.
5. Replace auger belt.
8
17