Motion CM-19 Manual página 7

2 Pair a scene
Shortly press the program button on the motor. (Tip : Use channel select on your remote)
2.1
The blind will start stepping, indicating the program mode has been activated.
The blind remains stepping until the program mode is de-activated.
play
Select a desired scene for the blind by pressing the scene + / - button on the domotica box until the
2.2
desired scene has been found. ( Scenes 1-15 can be used for saving scenes.)
2.3
Press the pair button on the domotica box to save the position of the blind.
To program a stop scene simultaneously hold the pair + unpair buttons the screen will display a
S indicating that a stop scene has been saved.
To remove the blind from a (stop)scene press the unpair button while the motor is in program mode.
To save the position of the blind you have to pair your blind
to a scene on your domotica box. Any scene from 1-15 can be
used to save the position of the blind.
scene pair unpair
+ -
2. PAIR A SCENE