Publicidad
Idiomas disponibles
Idiomas disponibles
Alarm
Your O3 Pure LS unit is equipped with an internal leak detector. If a leak happens to
develop inside of the unit, water will accumulate on the bottom panel. The sensor will
set off an audible alarm and will automatically turn the unit off. This alarm will continue
to buzz until the leak is stopped and/or the unit is unplugged. If this alarm should occur,
you should unplug the unit, turn off the cold water valve and call your distributor for
assistance.
Indicator Light
The Indicator light, viewed through the window on the front of the O3 Pure LS unit, as
two states of operation. (Fig. g)
A blue light indicates the normal operating condition of O3 Pure LS unit. (g.1)
A flashing red light indicates that the fan or the active oxygen generator is not operating
properly. Please contact your distributor for service. (g.2)
Note: The unit may briefly flash red then turn solid blue at the beginning of some fill/rinse
cycles. This is usually normal as the units rebuilds pressure. In some instances it may
also indicate a partially clogged filter located just inside the cold water intake in some
washing machines.
The use of your O3 Pure LS unit is very easy and convenient. As long as you install your
O3 Pure LS properly, you simply operate your washer according to the instructions pro-
vided by the manufacturer. O3 Pure LS is designed to automatically turn on as soon as
the washer demands water for the wash cycle and again for any rinse cycles. The only
differences are that you ONLY USE THE COLD WATER setting for both the wash and
rinse cycles on your washer.
Keep in mind that the fibers in your clothes are most likely saturated with residual
detergent. It may take up to 5 washes to remove this residue. During this initial phase
your laundry water may sud and clothes especially heavier items like bath towels may
come out stiff and crusty. This is normal as the Ozone breaks down that embedded
detergent. After this initial process, your laundry will begin to be odor free and soften up.
Also it can take up to 15 washes to remove old detergent residue from your
washer itself. Excessive iron, mineralization or exceptional poor water quality may
void the warranty on your O3 Pure LS.
with heavy mineralization and/or iron content, as mentioned we recommend installing
a pre filter directly before the O3 Pure LS. These can be obtained at a reasonable price
from your distributor. They will extend the operation life of your new O3 Pure LS unit and
enhance it's cleaning power.
Note: If hot water is used it dilutes and defeats the effectiveness of the enhanced and
Photo Catalytic Oxidizers that the O3 Pure LS unit has introduced into the wash water.
We suggest that you pre-treat stains, just as you would without an O3 Pure LS unit. For
normal soiled laundry, you should only need a very small amount of detergent or none at
all.
Page 4
Alarm & Indicator lights
Using Your O3 Pure LS
Daily Use
If you have water, especially well water
Stains
Copyright © 2017 Pure Energy LLC - All Rights Reserved
Publicidad
