Install The Load Bars - Gallagher LOADBARS Instrucciones Para La Instalación

INSTALL THE LOAD BARS
Note: Do not use an arc welder on either the platform or the load bars. Use of an arc
welder may damage the load cells.
1. Position the load bars on the foundation to suit the platform or crate. The
load bars should be located as close as possible to the ends of the platform
or crate.
2. Ensure that the load bar feet sit flat on the board or concrete pad.
3. It is recommended that the load bars are secured to the foundation. To
secure the load bars, follow these steps.



Note:
Ensure that the load bar chassis does not twist or distort as the fasteners are
tightened. If the load bar feet do not sit flat on the foundation, grout the
surface to suit.
4. Attach the crate or platform to the load bars using the fasteners supplied.
Page 4
Mark the load bar feet holes on the foundation.
Drill and fit fasteners to suit the type of foundation. Dynabolts can be
used with concrete foundations; bolts, nuts and washers can be used
with board foundations.
Tighten the fasteners to secure the load bars to the foundation.
3E1045 Gallagher Load Bar User Manual