Technical Data - Solar-Log Sensor Box Manual De Instalación

Installation Manual Sensor Box
2.5 Starting Up at the Solar-Log
By switching-on the Solar-Log
Sensor Box. Afterwards, the Sensor Box must be configured
to the free RS485-port:
 On the display, open the Config/Start/Initial config dialog box
 In the inverter selection, tick the "M&T Sensor" box
 Carry out the inverter detection
The Sensor Box is integrated with the system in the same way
as an inverter. The further configuration could be handled with
TM
the Solar-Log web interface.
2.6

Technical Data

Sensor Box
Dimensions, weight
Housing
Protection mode
Operating temperature
Power supply
Tolerance
Installation
Connection cable
Conformity
TM
TM
, it will provide power to the
W/H/D in mm: 145/85/40, 360 g
Metall
IP65
-20 °C to +70 °C
Via RS485 data cable from Solar-Log™
(12-28 V )
DC
Irradiance : ± 5% (0 W/m² to 1400 W/m² )
Cell-temperature: ± 1K (-20 °C to +70 °C)
with screws on the substructure
4-wire, 3 m
CE :DIN EN-61000-6-1:2007 and
DIN EN-61000-6-3:2007
TM
Solar-Log Sensor Box Installation | 9 von 28