Setting Up
1.
Connect the sensor.
2.
Turn on the DPM.
3.
Zero the sensor (WPS and TPS only).
4.
Turn on the RF source.
5.
Take a reading.
The analog bar graph will respond immediately to changes in the
Note:
RF power. The major and minor displays will respond after a delay of 1 to
13 seconds, depending on the power level.
Shutting Down
Press and Hold the "OK" key for 2 seconds. This will put the unit into Sleep
mode. It will stop logging in this mode.
Press and hold the "OK" key until the "OK" key illuminates, approximately 8
seconds. This will shut the unit down completely.
920-5000-XT-QSG Rev B
TRANSMITTER/
GENERATOR
USB
POWER METER
SERIAL
www.birdrf.com
TO SENSORS
WIDEBAND POWER SENSOR
USB
DIRECTIONAL POWER SENSOR
USB
TERMINATING POWER SENSOR
POWER METER TO PC
POWER METER
USB
ANTENNA
SERIAL
ANTENNA
SERIAL
USB
SERIAL
PC
(866) 695-4569