Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Basic Button Functions
Button
<OK> (when Off)
<OK> (when On)
<OK> for 8 seconds (when
On)
<MENU>
<LOG>
<.> for 2 seconds
<0> for 2 seconds
<5> for 2 seconds
<8> for 2 seconds
<9> for 2 seconds
<+/->
Upgrading the Firmware
1.
Power on the 5000-XT
2.
Connect the USB from the 5000-XT to the PC and wait for the drive to appear.
Note: This could take 30 seconds
3.
Create a folder named "FIRMWARE".
Note: If there is already a folder, use the existing folder, but delete any firmware
versions already in that folder.
4.
Place the attached firmware file into the folder.
Note: This file can be named anything as long as the file extension is .bin.
5.
Eject and disconnect the 5000-XT from the PC.
6.
Press the Menu key.
7.
Select Setup on the Main Menu.
8.
Select Update Firmware on the Setup Menu. The Update Firmware file list will display.
9.
Select the newly downloaded firmware file from the list.
10. Select accept when asked "Update System Firmware?"
Note: The file will be checked. If file is corrupt, it will notify as such.
11. The following screens will be displayed:
a.
"Loading" screen
b.
"Erasing Flash" screen with a progress bar
c.
"Writing Flash" screen with a progress bar.
d.
"Update SUCCESS" screen.
12. Select OK when prompted after the message: "The system will now power down.".
For additional information, operators manual, and firmware updates, go to:
920-5000-XT-QSG Rev B
Max Hold - Will show the largest recorded reading
http://www.birdrf.com and search for 5000-XT
www.birdrf.com
Turns the unit On
Puts the unit in Sleep Mode
Turns the unit Off
View menus for setting up unit & sensor
Start/Stop data recording
Performs a screen capture
Performs a Zero calibration if applicable
Brings up the Language Select screen
Enables Smoothing
Toggles between large and small displays
Function
(866) 695-4569
Publicidad
Tabla de contenido
