EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET
■ If any parts are damaged or missing, please call your
Cramer service centre for assistance.
PACKING LIST
■ Lawn mower
■ Battery key
■ Grassbox
■ Mulching plug
■ Side discharge deflector
■ Operator's manual
■ Knobs
■ Bolts
If any parts are damaged or missing do not operate this
product until the parts are replaced. Using a product
with damaged or missing parts could result in serious
personal injury.
Do not attempt to modify this product or create
accessories not recommended for use with this product.
Any such alteration or modification is misuse and could
result in a hazardous condition leading to possible
serious personal injury.
Do not insert battery key until assembly is complete and
you are ready to mow. Failure to comply could result in
accidental starting and possible serious personal injury.
To prevent accidental starting that could cause serious
personal injury, always remove the battery pack from
the product when assembling parts.
Never operate the mower without the proper safety
devices in place and working. Never operate the mower
with damaged safety devices. Operation of this product
with damaged or missing parts could result in serious
personal injury.
UNFOLDING AND ADJUSTING LOWER HANDLE
See figure 2.
English (Original Instructions)
WARNING
WARNING
WARNING
WARNING
WARNING
■ Pull and rotate the handle knobs 90° on both sides to
loosen the lower handles on both sides.
■ Move the lower handles to the operating position. You
may raise or lower the handle to a position comfortable
for you. There are 3 positions for you to choose.
Release the handle knobs to lock the lower handle
into position.
NOTE: Ensure both sides are set at the same position for
proper assembly.
INSTALLING THE UPPER HANDLE
See figure 3.
■ Align the mounting holes on the upper handle and the
lower handle. Insert the carriage bolts and use the knobs
to tighten them. Repeat the operation on the other side.
INSTALLING THE GRASSBOX
See figure 4.
■ Lift the rear discharge door. Remove the mulching
plug if previously installed.
■ Lift the grass catcher by its handle and place under
the rear discharge door so that the hooks on the grass
catcher are seated on the door rod.
■ Release the rear discharge door. When installed co
rrectly, the hooks on the grass catcher will extend
through the openings on the rear discharge door.
INSTALLING THE MULCHING PLUG
See figure 5.
■ Lift and hold up the rear discharge door.
■ Grasp the mulching plug by its handle and insert it at a
slight angle, as shown.
■ Push the mulching plug securely into place.
■ Lower the rear discharge door.
INSTALLING SIDE DISCHARGE DEFLECTOR
See figure 6.
NOTE: When using the side discharge deflector, do not install
the grassbox. The mulching plug should remain installed.
■ Lift the side discharge door.
■ Align the hooks on the deflector with the hinge rod on
the underside of the door.
■ Lower the deflector until the hooks are secured on the
mulch door hinge rod.
■ Release the deflector and side discharge door.
SETTING BLADE HEIGHT
See figure 7.
When shipped, the wheels on the mower are set to a low-
2