Hamilton Beach Commercial HIR800 Manual Del Usuario página 4

840136500 ENv01.qxd 3/11/05
Sensor Control
RED Light
Solid
Power OFF ( O )
Blinking
Iron was heating/reheating and went to OFF (
O ). Iron will reheat when moved.
GREEN Light
Solid Iron is heated and ready for ironing.
Blinking Iron is preheating/heating.
To Dry Iron
1. Plug in iron.
2. Turn Adjustable Steam to the Dry Iron position.
3. Set Temperature Selector to desired temperature. With
iron in an upright position, allow 3 minutes for iron to reach
desired temperature. Do not preheat iron with soleplate
facing down.
4. To turn iron off, set Temperature Control to OFF ( O ). The
iron may be turned off by pressing the Temperature Setting
Button for 3 seconds.
To Steam Iron
1. Unplug iron. Open water tank fill cover. Using a cup, slowly
pour 6 ounces ( ⁄ cup) of tap water into the water tank
3
4
opening. Close water tank fill cover.
2. Plug in iron.
3. Set Temperature Selector to desired setting in steam
range. With iron in an upright position, allow 3 minutes
for iron to reach desired temperature. Do not preheat iron
with soleplate facing down.
9:40 AM Page 6
6
4. Set Adjustable Steam to desired steam output.
5. To turn iron off, turn Adjustable Steam to Dry Iron.
Set Temperature Control to OFF ( O ). The iron may be
turned off by pressing the Temperature Setting Button
for 3 seconds.
6. Empty water from the iron following directions in "Caring
for Your Iron and Soleplate."
Water
Please use ordinary tap water. If you have extremely hard
water, alternate between tap water and distilled water for
use in the iron.
Features
(on selected models)
Adjustable Steam
Provides minimum steam for wool or
maximum steam for linen. Set the dial
to to change to Dry Iron.
Blast of Steam and Spray Buttons
Push Steam Button for an extra blast of
steam. Push Spray Button to release a
fine spray of water for difficult wrinkles in
cotton or linen.
7
Steam Spray