Troubleshooting; Environmental Protection - Samoa 160 500 Manual Del Usuario

EN
NON-RETURN VALVE CLEANING
Dirt or particles may cause a failure of the grease dispenser. If the gun is
properly primed and grease delivery problems persist, perform the
following cleaning procedure:
SPECIFICATIONS
Voltage
Maximum working
pressure limited by
safety valve
Flow
Grease type
Grease capacity
1 NLGI-2 grease is used with a back pressure of 10 bar that simulates
passage through a lubricator.

TROUBLESHOOTING

Problem
The gun does not dispense grease
Motor doesn't work or works at very
low speed
The battery does not recharge or lasts
only a short time
Leakage from pressure relief valve
Grease tube thread leakage

ENVIRONMENTAL PROTECTION

The above symbol indicates that, in accordance with
local regulations, your product and/or battery should
be disposed of separately from household waste. When
this product reaches the end of its life, it must be taken
to a collection point designated by the local authorities.
8
816 809 R. 10/20
SAMOA Industrial, S.A. · Pol. Ind. Porceyo, I-14 · Camino del Fontán, 831 · 33392 - Gijón - Spain · Tel.: +34 985 381 488 · www.samoaindustrial.com
20 V
7250 psi (500 bar)
100 g/min ("L" mode)
160 g/min ("H" mode)
Up to NLGI-2
450 g (bulk)
400 g (cartridge)
Cause
Empty grease tube or cartridge
Loss of prime
Grease point obstructed
Dirt on non-return valve
Discharged battery
Motor breakdown
Charger power failure
Damaged battery
Damaged charger
Grease point obstructed
Seal out of place or dirty gasket
Damaged seal
1. Unscrew the safety valve.
2. Remove the spring and ball.
3. Clean the ball and valve seat.
4. Reassemble the ball and spring and tighten the safety valve.
Functions Battery level, cartridge grease estimation,
grease meter estimation, unit change
(g/oz), loss of priming alarm, stall alarm,
LED light
Battery
Li-Ion 2.0/4.0 Ah
Battery charger
220V-240 VAC
Charging time
70-90 min (2 Ah)
Hose length
110 cm (43")
Weight
3 kg / 6.6 lb (with tube and 2Ah battery)
Solution
Refill tube or replace cartridge
See "Gun priming" section
Check installation
Disassemble and clean valve
Recharging the battery
Contact technical service
Check charger connection
Replace the battery
Replace the charger
Check installation
Check the seal
Replace seal
The separate collection and recycling of the product or its battery at the
time of disposal will help to protect natural resources and ensure that it
is recycled in a manner
and the environment.
that protects human health