Elma MULTI 5 Manual Del Usuario página 22

English
3.4 Use of blender accesory
(Sold separately)
Blender accesory parts list
b
a
c
d
1. With the machine disconnected, attach the blender unit (a) to the motor
unit. Insert the head into the slot on the motor unit whilst pressing the
connection button (5), you will hear a click when it is attached (Figure 1).
Once attached, rotate the unit softly until the neck is locked perpendicular
(Figure 2)
2. Insert the feed screw (b) through the mouth of the blender unit, attaching
it to the motor unit output shaft (Figure 3)
3. Proceed to insert the cone filter (c) inside the blender unit until it reaches
the end.
4. Lastly, place the cap (d) on the blender unit. Having installed the cap,
rotate it anti-clockwise to fasten the assembly. The cap contains a selector
22