For Multiple Keops Tm Solar Heater; For Pools Using Hose Connection Of Dia. 57Mm(2 1/4In) Soft - Kokido Keops Manual De Usuario

2) For pools using hose connection of Dia. 57mm (2 1/4in) soft hose with
Threaded Nut
a) Detach the pool return hose from your pump/filter.
b) Use soft hose of either Ø32mm (1 1/4in) or Ø38mm (1 1/2in) or to connect the
center hose connector to the pump/filter. Make sure the hose is secured by the hose
clamp.
c) Screw the threaded nut hose connector to the side hose connector. Make sure the
O ring is inside the threaded nut hose connector.
d) Screw the threaded nut of the hose, which is connected to the pool return inlet, to
the threaded nut hose connector. Make sure the flat gasket is placed between
threaded nut hose connector and hose threaded nut.
TM
3) For multiple KEOPS Solar Heaters
Depending on the weather conditions, 1 heater is recommended per 10,000 liters of
pool volume.
NOTE: Make sure to have enough hose clamps and hose reducers before linking
additional solar heaters. A hose reducer is required for Ø38mm(1 1/2'in) hose
connection, and a hose clamp should be used to secure all hose connections.
For one additional solar heater, use short hose provided and hose reducer to connect
the additional solar heater.
11