General Information; How It Works; Points To Note; Keops Tm - Kokido Keops Manual De Usuario

General Information

TM
KEOPS
Solar Heater features an innovative dome design that provides better heat
transfer than traditional solar systems, and also eliminates the need to set aside yard
space for conventional solar panels.
With the hose connectors provided, KEOPS
which require either Ø32mm (1 1/4in) / 38mm (1 1/2in) soft hose connection or
Ø57mm (2 1/4in) threaded nut hose connection.

How It Works

TM
KEOPS
Solar Heater should be installed between the pump / filter and return inlet
of the pool. Cold water flows from the pool water outlet to the pump/filter and through
the solar heater. Water is heated while flowing through the heater coils, and then
back to the return inlet of the pool.

Points to Note:

1) Installation
Before installation, make sure you have filled your above-ground pool with water and
it is connected with necessary filtration hoses which are connected with the filter and
pump.
The solar heater will become very heavy after filling with water. Select a proper site
for the solar heater before installation. The solar heater should be installed, lower
than the pool water lever, on a completely level, very firm ground or equivalent. The
solar heater should face in a SOUTHERLY direction and its stand should be released
for an optimal solar angle.
WARNING
: Turn off the pump before installation and disconnecting the solar heater
from your filtration system.
WARNING
: Never place the solar heater close to any pool chemicals as chemical
fumes and/or spills can cause severe corrosive attack.
CAUTION
: The solar heater must be positioned so as to prevent it being used as
means of access to the pool by young children.
CAUTION
: Never stand or sit or put any object on the main base and dome cover.
2) Solar heater operating pressure
Make sure that the solar heater operating pressure must not exceed 1.5bar (21psi). It
is recommended to have a pressure gage installed before the solar heater after the
pump/filter to monitor the water pressure going inside the solar heater.
TM
Solar Heater fits filtration systems
6