Dri-Eaz Sahara Pro X4 TurboDryer Airmover El Manual Del Propietario

Sahara Pro X4 TurboDryer
to accelerate the evaporation of moisture from structural and other materials.
R E A D A N D U N D E R S T A N D B E F O R E O P E R A T I N G
WARNING! To reduce the risk of fire or
electric shock, do not use this fan with any
solid-state speed control device.
WARNING! Unit must be grounded. Do not
use with an extension cord. Connect only to an outlet provided
with a ground fault interrupting device.
WARNING! Never operate a unit with a damaged power cord, as
this may lead to electrical or fire hazards. If power cord is
damaged, it must be replaced by an approved Legend Brands,
Inc., power cord.
WARNING! Do not touch grills when unit is operating.
WARNING! Do not allow children to play with or around the unit.
Be sure the unit is inaccessible to children when not attended.
WARNING! Always operate the unit on a stable, level surface so
it cannot fall and cause injury.
WARNING! Do not operate any fan with a damaged cord or plug.
Return to an authorized service facility for assessment and/or
repair.
WARNING! Do not route cord under carpeting. Do not cover cord
with throw rugs, runners, or similar coverings. Do not place cord
under furniture or appliances. Arrange cord away from traffic area
to avoid creating a trip hazard.
NOTICE: Keep motor and electrical components dry. For indoor
use only.
NOTICE: Unplug when not in use or when moving unit.
Fig. A: Parts Identification
Carry handle
Speed control
Circuit breaker reset switch
Convenience outlet
Air inlet grill. Keep
clear of obstructions.
124082D
Owner's Manual
LEGEND BRANDS, INC.
15180 Josh Wilson Road, Burlington, WA 98233, USA
Phone: +1 800-932-3030
The Sahara produces high velocity airflow for ventilation and
Patents: LBpatents.com
®
LegendBrandsRestoration.com
NOTICE: Do not alter or modify your airmover in any way. Use
only replacement parts authorized by Legend Brands, Inc.
Modifications or use of unapproved parts could create a hazard
and will void your warranty.
BEFORE YOU BEGIN
Warranty registration
Please visit warranty.LegendBrands.com
Registration allows Legend Brands to better assist you with the
operation and maintenance of your equipment, and to contact you
in case there is important safety information concerning your
Legend Brands product. If you wish to make a warranty claim,
have your equipment model, serial number and original proof of
purchase available and call your distributor from which you
purchased the unit (or the Legend Brands Service Department at
800-932-3030) for assistance with obtaining a return material
authorization (RMA).
OPERATING INSTRUCTIONS
1. Ensure control knob in the off position. Unwrap the cord and
plug the unit into a standard 115V GFCI-protected outlet.
2. Direct the Sahara air outlet where desired. Unit may be
operated in 4 positions (0°, 10°, 45° or 90°) for drying floors,
walls, stairways or ceilings.
3. Set the control knob to the desired speed.
4. Carpet Clamp: To "float" a carpet, use the Carpet Clamp
(Fig. A) to secure the edge of the carpet over the top of the
snout to direct airflow underneath the carpet.
1
Airmover
to register your product.
Cord wrap. Secure
cord with plug clip.
Air inlet grill. Keep
clear of obstructions.
Carpet clamp.
Air outlet grill. Keep clear
of obstructions.
Legend Brands, Inc.