Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
This manual is designed to make it as easy as possible for you
to assemble, install, operate, and maintain your Rejuvenation ceiling fan
Tools Needed for Assembly
• One Phillips head screwdriver
• One stepladder
• One ¼" blade screwdriver
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 9). If you feel you
do not have enough wiring knowledge or experience,
have your fan installed by a licensed electrician.
For your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all
s
e t
p
s
h
a
v
e
b
e
e
n
c
o
m
p
Do not install or use fan if any part is damaged or
missing. This product is designed to use only those
parts supplied with this product and/or any accessories
designated specifically for use with this product by
Fanimation. Substitution of parts or accessories not
designated for use with this product by Fanimation could
result in personal injury or property damage. Contact
Rejuvenation at 888.401.1900 for missing or damaged
parts.
1. Check to see that you have received the following
parts:
NOTE: If you are uncertain of part description, refer to
exploded view illustration.
Hanger Bracket
Assembly
Fan Motor Assembly
• One wire stripper
• Four wire connectors
(supplied)
WARNING
Unpacking Instructions
e l
e t
d
a
n
d
w
l l i
b
e
h
l e
f p
l u
WARNING
Wiring outlet box and box connectors must be of type
required by local code. The minimum wire would be a 3-
conductor (2-wire with ground) of the following size:
Installed Wire Length
NOTE: Place the parts from the loose parts bags in a small
container to keep them from being lost. If any parts are missing,
contact Rejuvenation at 888.401.1900
n i
n i f
d
n i
g
y
o
r u
p
a l
c
e
s
h
o
• Fan Motor Assembly
• Hanger Bracket Assembly
• Downrod/Hanger Ball
Assembly
• 9˝ Downrod
• Ceiling Canopy
• Motor Coupling Cover Assembly
• Canopy Screw Cover Assembly
• Blade Holder Set
Ceiling Canopy
Canopy Screw
Cover Assembly
Motor Coupling
Cover Assembly
3
Materials
Up to 50 ft.
50 - 100 ft.
u
d l
y
o
u
b
e
i
t n
r e
u r
p
e t
. d
• Hardware bag:
– Nine ¼˝ -20 x 13 mm
Head screws with lockwashers
(blade holder to fan motor hub)
– Thirteen
washer head screws
(blade to blade holder)
– Four wire connectors
– Balance kit
– Two chain coupler
– Two chain fob
– Bag Assembly Safety Cable
– Phillips screwdriver,4˝
Downrod/
Hanger Ball
Assembly
Blade Holder Set
Wire Size A.W.G.
14
12
/
˝-24 x 11 mm
3
16
9 Downrod
Hardware Bag
Publicidad
Capítulos
Tabla de contenido
Solución de problemas
