E-STAR DUAL STRIKER-11 Manual Del Usuario página 3

3. UNFOLDING THE DRONE:
As below picture to unfolding the drone.
4. CHARGING YOUR DRONE BATTERY:
BATTERY WARNING:
Lithium Polymer batteries can expand, burst or catch fire if used incorrectly, causing both property damage and or personal injury. It is essential that you follow all the included
instructions and safety warnings in full. The manufacturer, distributors and retailers will assume no liability for the failure to comply with these safety instructions and warnings.
INSTRUCTIONS WHEN CHARGING:
1) The battery must be removed from the product (As pic.1 and pic. 2) before charging.
2) If the battery has just been used, please let it cool down to room temperature before charging.
3) Charging must only be undertaken by an Adult, and only using the charger included with this product.
4) Always charge the battery on a non flammable heat resistent surface with non flammable surroundings.
5) Connect the battery to the USB charging cable.
6) Connect the USB Charging cable to your USB Charging devices. The RED LED on the USB will Trun On while charging, and will Turn Off once the battery is fully charged. It
takes around 45 minutes to fully charge the battery. Never continue to charge the battery after the RED LED have Turned Off.
7) Lithium Polymer batteries do not last forever. If your battery becomes damaged in a crash or no longer charges properly, immediately replace it with a new battery. To prolong
the life of your battery, it is always best to retain a bit of charge in your battery prior to charging it.
pic.1
5. SAFE FLIGHT ENVIRONMENT:
1. Make sure the surrounding area is free of all people, pets or other obstacles before you start to fly.
2. The Drone is designed for Outside flying, or Indoors if you have enough space. Do not use in strong wind.
3. Leave 1.5 meters between you and the Drone at all times.
6. SETTING UP THE SIGNAL CONNECTION:
pic.2
Step 1
Inset the battery to the battery housing. (see first picture). Turn on the power switch of the Drone - the
LED's on the drone will start to flash. Place the Drone down on a flat surface, making sure the drone is
facing away from you.
power switch
Step 2
Turn on the controller Power Switch, The controller will make 2 short BEEP sounds and the Blue LED of
cotroller will flash and start pairing the signals of the Drone and the Controller, (NOTE: You could not need
to push the left lever) just waiting for 3 seconds, the controller will make one short BEEP, signal pair will
finish and the LED light will become constant lighte, indicated the signals pair is beening finished.
Step 3
Always Trun off the Power Switch of the drone after flight(By press for 1 second).
Only USB charging cable that inside packaging can be
used for charging.
pic.3
REMARK: