Stone Mud Buggy SB1600 Manual Del Operador página 46

Maintenance
MUD BUGGY
46
BATTERY
For battery replacement call Exide at 800-782-7848 for battery equal to 12V 165 CCA battery.
See Engine Specifications Section for battery requirements.
Battery vapors can explode. Keep sparks and flames away from batteries. Use a flashlight to
check battery electrolyte level. Never check battery charge by placing a metal object across
the posts. Use a voltmeter or hydrometer. Sulfuric acid in battery electrolyte is poisonous. It
is strong enough to burn skin, eat holes in clothing, and cause blindness if splashed into
eyes.
Avoid hazard by:
- Filling batteries in a well-ventilated area.
- Wearing eye protection and rubber gloves.
- Avoid breathing fumes when electrolyte is added.
- Avoid spilling or dripping electrolyte.
- Use proper jump start procedures.
If you spill acid on yourself:
- Flush your skin with water.
- Apply baking soda or lime to help neutralize the acid.
- Flush your eyes with water for 10 - 15 minutes. Get medical attention
immediately.
If acid is swallowed:
- Drink large amounts of water or milk.
- Then drink milk of magnesia, beaten eggs, or vegetable oil.
- Get medical attention immediately.
• Once a month check the battery condition. With engine off, check the battery for
12.5 volts with a voltmeter or check the specific gravity of the electrolyte fluid in
each cell.
• Check for proper electrolyte fluid level. Use distilled water when adding and run 30
minutes to mix. Clean battery, posts, and
before charging to avoid damage to the electrical system.
• Once a month, check the charging system with the engine running at full speed for
13 - 14 volts with a voltmeter to ensure engine voltmeter readings are correct.
• Keep batteries clean by wiping them with a damp cloth. Keep all connections clean
and tight. Remove any corrosion and wash terminals with a solution of 1 part
baking soda and 4 parts water. Tighten all connections and check that the battery is
securely fastened with properly installed hold downs.
N N N N N O O O O O TE: TE: TE: TE: Coat battery terminals and connectors with a mixture of petroleum jelly and baking
TE:
soda to retard corrosion.
• Keep battery fully charged, especially during cold weather. If a battery charger is
used, turn charger off before connecting charger to battery. Attach POSITIVE (+)
battery charger lead to POSITIVE (+) battery post. Then attach NEGATIVE (-) battery
charger lead to a good ground.
terminals. Disconnect battery cables