English
Owner's manual
sure that the saw chain stops moving
when the throttle control trigger is released.
Never adjust the guide bar or saw chain
when the engine is operating.
· Beware of carbon monoxide poisoning.
Operate the chain saw in well ventilated
areas only.
· Do not attempt a pruning or limbing
operation in a standing tree unless
specifically trained to do so.
· Guard against kickback. Kickback is the
upward motion of the guide bar that occurs
when the saw chain, at the nose of the
guide bar, contacts an object. Kickback
can lead to dangerous loss of control of the
chain saw.
· A chain saw is intended for two-handed
use. Serious injury to the operator, helpers
and/or bystanders may result from one-
handed operation.
· When carrying a chain saw with the engine
running, engage the chain brake.
· Allow your chain saw to cool before
refueling, and do not smoke.
· Don't allow other persons or animals close
to a running chain saw or close to where a
tree is being felled.
· Use extreme caution when cutting small
size brush and saplings because slender
material may catch the saw chain and be
whipped toward you.
· When cutting a limb that is under tension
be alert for spring-back.
5. INSTALLING GUIDE BARAND SAW
CHAIN
A standard saw unit package contains the
items as illustrated, (F1)
(1) Power unit
(2) Bar protector
(3) Saw chain
(4) Guide bar
(5) Screwdriver for carburetor adjustment
(6) Spark plug wrench
(7) Spike and mounting screws
Open the box and install the guide bar and the
saw chain on the power unit as follows:
34
7
WARNING The saw chain has very sharp
edges. Use thick protective gloves for safety.
1. Pull the guard towards the front handle to
check that the chain brake is not on.
2. Loosen the nuts and remove the chain
cover.
3. Install the attached spike to the power unit.
4. Gear the chain to the sprocket and, while
fitting the saw chain around the guide bar,
mount the guide bar to the power unit.
Adjust the position of chain tension nut on
the chain cover to the lower hole ofguide
bar.
(8) Hole
(9) Tension nut
(10) Chain cover
10
1
2
3
4
6
5
8
9