Lorex E893AB Serie Guía De Inicio Rápida página 24

Ocultar thumbs Ver también para E893AB Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

4.
Picture is too dark.
• Check the brightness and contrast settings on the NVR.
5.
Night vision is not working.
• The night vision activates when light levels drop. The area may have too much light.
6.
Bright spot in video when viewing camera at night.
• Night vision reflects when pointing a camera through a window. Move the camera to a different location.
7.
Picture is not clear.
• Check the camera lens for dirt, dust, spiderwebs. Clean the lens with a soft, clean cloth.
• Make sure that the cable run is within the limitations specified in the section 'Cable Extension Options'.
• Remove the vinyl film from the camera lens when your installation is complete.
8.
Picture is in color in in dark conditions.
• This camera's image sensor is extra sensitive to light, meaning that the camera stays in color mode at
low-light conditions. For instructions on how to make your camera switch to night mode, visit lorex.com,
and search for "How do I make my camera switch to night mode?".
9.
The camera warning light is not switching on automatically.
• Ensure that you have enabled and configured white light deterrence using a compatible NVR. See your
NVR's documentation for full instructions.
• Ensure the active areas and schedule for white light deterrence are set properly. The default schedule for
the warning light is night times (between 5PM and 7AM).
20

Publicidad

Tabla de contenido
loading

Tabla de contenido