Fixing The Unit; Transforming Dx Version (Outlet Pipes Fi Tted On The Right) Into Sx Version (Outlet Pipes Fi Tted On The Left) - Sistem-Air BASIC LT 80 Manual Tecnico

Industrial Clean Basic Instruction manual
ByTecnoplus
s.r.l.
CENTRAL VACUUM SYSTEMS

14.3 Fixing the unit

The unit does not need any special fi xing device. For a correct and safe positioning, it is however nec-
essary to check that the location selected for installing the unit features the following min. requirements:
- a solid, perfectly fl at and horizontal bearing surface;
- the surface must not vibrate. Furthermore it is of utmost importance to avoid any unevenness of the
bearing surface that could make the unit unstable.
14.4 Transforming DX version (outlet pipes fi tted on the right) into SX version (outlet pipes
fi tted on the left)
The units are generally supplied with suction and exhaust pipes on the right side (RIGHT version). If
needed, the system can be transformed so to have both suction and exhaust pipe connections on the
left side (LEFT version).
To do this:
Disassemble the intake of the "A"
suction pipe and the "B" closing
plate by removing the screws.
B
16
1
A
A
After exchanging their housings, re-
2
assemble the intake of the "A" suction
pipe and the "B" closing plate by fas-
tening the screws.
Now rotate by 180° the intake of the
suction pipe as shown in the picture.
B
06/06/2016 Rev:2.0.0