Troubleshooting - Xtech XTS-810 Guia De Instalacion

3. Next, cycle to the Bluetooth feature on the soundbar by pressing the
®
MODE button found on the right side panel and select it as the input source.
The blue indication will start blinking and a tone will be heard to indicate that
the soundbar has entered into the pairing mode.
4. Once the soundbar appears listed under the newly found Bluetooth
devices (XTS-810) of your wireless device, select it and wait a few seconds
for pairing.
5. When pairing is successful, the blue indication will stand still and a tone will
be heard indicating that the Bluetooth
pairing process fails, please repeat steps 1 through 5 described above.
6. You can now start streaming audio through the soundbar wirelessly from
your favorite Bluetooth - enabled devices.
®
7. The soundbar will re-pair automatically to the memorized device when the
BT mode is selected on the unit after being turn off and on again.
Note: In Bluetooth mode, the soundbar will automatically turn off if the unit
®
hasn´t been active for about 10 minutes.
In any of the other modes, the LED display will automatically turn off if the unit
hasn´t been active for about 20 minutes. The soundbar will become active
again as soon as any button is touched.
®
is connected. If after 60 seconds the
®
VII. Troubleshooting
PROBLEM CAUSE
There is no audio signal The soundbar is not
when the soundbar is paired to the audio source
connected to Bluetooth
®
The volume is too low
The soundbar can't be The audio source is
connected to the turned off
Bluetooth There is an existing device
®
connected via Bluetooth
The Bluetooth
connection is turned off at
the audio source
Poor sound coming out The Bluetooth
when connected to out of the wireless range
Bluetooth
®
The remote control is The battery is exhausted
not working properly The remote control is not
pointing directly into the
IR receiver on the
soundbar
SOLUTION
Check if the connection has been
established and in case it hasn't,
pair the soundbar to your device
again
Increase the volume in the audio
source or in the soundbar
Turn on the audio source
Unpair the existing device and pair
the soundbar with the new device
®
Turn on the Bluetooth feature in
® ®
the audio source
device is Place the Bluetooth device closer
® ®
to the soundbar
Replace the battery
Point the remote control to the IR
receiver within the specified
wireless range