Installation Guide; Operation Guide - Black and Decker BD60316 Manual De Instrucciones

SET UP & USE

INSTALLATION GUIDE

1. Unpack your wine cellar by removing all packaging materials like carton, base,
foams, adhesive tape, etc.
2. Remove all accessories, internal packaging material that was used to hold shelves,
etc., in place during transport.
3. Clean the remains of all adhesive tape used and remove all printed material
supplied.
4. Install the wine cellar in a convenient location away from extreme heat and cold.
Allow sufficient clearance between the wine cellar and side wall so the door(s)
will open without obstruction. Wine cellar is not designed for recessed or built-in
installation.
5. The floor on which the wine cellar should be placed must be flat, hard, solid, and
even. The wine cellar should not be placed on any soft material such as carpet,
foam, plastic, etc.
6. To level your wine cellar, use the two leveling legs in the rear and one in the front
left of your wine cellar. Adjust by turning the legs counter clockwise to raise or
counterclockwise to lower your wine cellar.
NOTE: The front right leg that is part of the door hinge bracket is not adjustable.
7. The following are recommended minimum clearances around the wine cellar for
proper air circulation:
Sides: 2" (50mm)
Top: 4" (100mm)
Back: 2" (50mm)
Proper air circulation will help your wine cellar work at maximum efficiency.
NOTE: · Allow enough space in the front of the unit to open door to at least 120˚.

OPERATION GUIDE

1. Plug in the wine cellar to power the unit on.
2. You may choose a temperature setting for your wine cellar within the range of 46° to
66° Fahrenheit . The temperature of your wine cellar can be set by pressing the up
arrow on the exterior of the door you can raise the temperature. By pressing the
down arrow
have completed your set temperature selection, the temperature readout will revert to
the actual temperature.
Page 10
on the exterior of the door you can lower the temperature. Once you