Installing The Kit - CATU CZ-55 Instrucciones De Uso

CZ-55.indd 2
ARABE

Installing the kit:

To protect this kit during transport, all components are placed inside the cabinet.
To facilitate wall mounting, we recommend emptying it of its component parts.
ΠMount the angle brackets on the wall taking care to match the precise distance of 600 mm between
brackets (using two screws per bracket).
Be sure to mount the cabinet 1510 mm from the floor. See Diagram A page 10.
 Place the cabinet onto the angle brackets and clip the two pressure mounted plastic clips into
place. See Diagram B page 10.
Ž With the cabinet still on the wall, drill the wall through the two holes located in the base of the
cabinet.
Press the wall plugs in and screw in the two screws after inserting the washers. See Diagram C page 11.
 Stow the component parts in the cabinet using the Velcro strips for boots, cable cutter and stool.
Extend the pole and mount the detector (so that this assembly is immediately operational).
Clip the pole into the location provided. See Diagram D page 11.
 Check that the detector operates properly (by pressing the red button).
12/02/13 11:16:01