Component Parts - CATU CZ-55 Instrucciones De Uso

Use:
This equipment is for use in assisting victims in case of electrical hazard.
Warning:
To ensure optimum protection, all insulating components must be used (stool,
gloves, pole).
The detector only works with AC power (no detection is possible when using DC
installations).
Before use, always check equipment integrity (especially the gloves).
Before and after checking to ensure that no voltage is present, always check correct
installation operation.
This check must be performed in contact with bare conductive parts.
Never cut a number of phases at the same time using the cable cutters (this causes
a short circuit hazard at blade level).

Component parts:

- a wall mounted cabinet with transparent doors and straps,
- an insulating stool 40 kV (Phase/Ground),
- a pair of insulating gloves, 36 kV (class 4) safe,
- a telescopic 45 kV safe pole,
- a saving hook,
- a type CL-4-03 3-40 kV 50/60 Hz power detector,
- a pair of boots (or clogs) for protection against «footfall voltages»,
- an insulated 25 kV cable cutter,
- a flask of talcum powder for enhanced glove use,
- a «CARE FOR ELECTROCUTION VICTIMS» poster,
- instructions for use,
- a wall mounting kit:
two angle brackets
six 6x35 round head screws
six wall plugs
six washers
two pressure mounted plastic clips
CZ-55.indd 3
ENGlISH
12/02/13 11:16:01