Loudspeaker Placement And Mounting; Block Diagram - SKP Pro Audio SK-6P El Manual Del Propietario

SK-6P

Loudspeaker Placement and Mounting

The following guidelines will help you achieve optimum sound wherever you use your SK-6P loud-speakers:
Raise the speakers as high as possible. For best results try to get the high frequency horn at least 2 to 4 feet above the
heads of the audience. If the speakers are too low, the people in the back of the audience will not receive the best quality
of sound.
Place the speakers between the microphones and the audience. Feedback occurs when the microphones pick up sound
from the speakers and "feed" the sound back through the sound system. If space is limited, point the speakers away
from the microphones to reduce feedback.
Locate the speakers away from turntables. Low-frequency feedback occurs when the output of the speaker is picked up
by the tone arm of the turntable and is re-amplified. A heavy, solid turntable base and shock mounting can also reduce
this type of feedback in DJ applications.
Use more speakers in large or highly reverberant spaces. Spreading speakers throughout these spaces will produce
much better sound than trying to compensate with loudness level or equalization. For very long distances, the use of
another set of speakers on a delay is recommended.
Stand speakers upright for PA-Tilt the speakers back for stage monitoring. Upright stance Provides even Coverage over
a wide, SK-6P speakers ane also designed with two slanted Positions for stage monitoring applications.

BLOCK DIAGRAM

OUT
INPUT 1
INPUT 1
LINE
MIC
MIC
INPUT 2
INPUT 2
INPUT 3
INPUT 3
LOOP
MIX
SIGNAL
EQ
SUM
LOW HIGH
11
BLOCK DIAGRAM
PEAK
HPF
90W
LPF
&
300W
DYNAMIC
FILTER