Quickstart; Set Volume - SKP Pro Audio SK-6P El Manual Del Propietario

SK-6P

QUICKSTART

1. Turn the INPUT 1,2,and 3 controls fully counter-clockwise.
2. Set the MIC/LINE switch.
If a microphone will be connected directly to INPUT 1, set the MIC/LINE position (disengaged). The MIC LED will
not illuminate when power is turned on.
If a mixer, CD player, cassette tape, or electronic musical instrument (the "source")will be connected directly to
INPUT 1, set the MIC/LINE switch to the LINE position (disengaged). The MIC LED will not illuminate when power
is turned on.
3. Set the EQ HF and LF controls to their center detented position.
4. Plug the power cable into a properly grounded 3-wire AC power.
5. Plug the XLR cable from the mixer or microphone into the INPUT 1 connector.
6. Connect unbalanced sources (if used) to the LINE2 and LINE 3 input connectors.
7. POWER UP PROCEDURE
First, switch on the power to the mixer, audio sources, or musical instruments that are feeding your SK-6P
Next, turn on the power switch (the front panel power indicator will illuminate).
Reverse this process when shutting down your system.

8.SET VOLUME

If you are using an audio mixing console, refer to the manufacturer's instructions to properly set gain structure.
Turn up your sources to the level that will be used in performance and talk, sing or play into the system.
Bring the INPUT 1 control up (clockwise) until the desired volume has been reached. If you are using a micro
phone, turn the INPUT 1 control up slowly to avoid feedback.
If you are using the INPUT 2 and INPUT 3 inputs, bring the INPUT 2 controls up until the desired volume has
been reached.
9.CHECK THE PEAK LED
The PEAK indicator flashes when the loudspeaker's on-board amplifier are approaching maximum output.
Occasional flashes are normal for very loud operation, However, if the PEAK LED stays illuminated, the
sound may be distorted and it is an indication that more speakers or a lower performance volume may be
required for your specific application.
3
QUICKSTART