Ugin ARTIS NEO Modo De Empleo página 29

Instructions for use (rev 290319) ARTIS NEO
 Page 4
 Page 5
5.5. Arrow key to right
- During programming, press this key to switch from one parameter to the next
- During a firing cycle, press this key to cancel the ongoing phase and move on to the next
5.6. Arrow key upward
- When the furnace is in "IDLE": press this key to change the program number
- During programming: press this key to change the value of the flashing parameter
- During a firing cycle: press this key to cancel the ongoing phase and move on to the next
5.7. Arrow key downward
- When the furnace is in "IDLE": press this key to change the program number
- During programming: press this key to change the value of the flashing parameter
- During firing: press this key to cancel the cycle and switch to "IDLE"
5.8. Arrow key to left
During programming, press this key to return to the preceding parameter.
UGIN DENTAIRE 27