Installation And Initial Operation - Imbera IMB 250 CPY Manual De Usuario

SECTION 3

INSTALLATION AND INITIAL OPERATION

Selection of Installation Places
Operating environment of the product is very important to ensure
that your product operates without any problem. When you are se-
lecting the operating environment,
• Do not place your product outdoors so that it shall be exposed to
weather conditions. (on a street, lane, etc.)
• Do not place materials such as cardboards, boxes, etc. in front of
the lower blinds to ensure proper cooling of your product.
• Place it at least one (1) meter away from heat sources. (stove, radi-
ator, electrical heater, etc.) (Figure 1)
• Do not expose to direct sunlight. Operation rate of your appliance
will be increased if sunlight hits the glass of your cooler. And this
causes an increase in the temperature of the products inside the ap-
pliance and the power consumption shall be increased. (Figure 2)
• Do not place it against A/C exhausts, under the fans and directly in
the door and window openings. (Figure 3)
• Air entrance and exit shall always be free and easy for proper opera-
tion of the compressor section of your appliance.
• Make sure that there is a clearance of 150 mm (15 cm) between the
wall and the rear side of your cooler when you are bringing the prod-
uct close to the wall.
Picture 1 Picture 2 Picture 3
18