Assembling Your Smoothie Signature - Back to Basics SMOOTHIE SIGNATURE Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

A
SSEMBLING
Before assembling your Smoothie Signature
base in warm, soapy water, rinse thoroughly and dry. Unscrew and disassemble the
valve for cleaning (see Cleaning Your Smoothie Signature
life of your smoothie maker, do not wash parts in the dishwasher.
1.
Position the rubber gasket down onto the circular flat surface in the blade base.
2.
Screw the blade base onto the bottom of the blending jar by twisting the blade
base counter-clockwise until tightened. Make sure that the blade base is tightly
fastened to the blending jar and that the rubber gasket is properly compressed
between the blending jar and the blade base.
3.
Press the lid onto the top of the blending jar. Press the clear lid cap in the
center of the lid or place the stir stick through the center of the lid if blending
liquids or frozen drinks.
4.
Place the blending jar onto the motor base so that the bottom of the blade base
is sitting flat on the motor base.
5.
Plug in the cord. Your smoothie maker is now ready to use.
Stir Stick
Lid Cap
Lid
Blending Jar
Dispensing Valve
Blender Cap
Y
S
OUR
MOOTHIE
wash all parts, except for the motor
4
S
IGNATURE
section). To prolong the
Rubber Gasket
Blade Base
Motor Base

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido