Descargar Imprimir esta página

HoMedics VC-101 Manual De Instrucciones página 3

Publicidad

Idiomas disponibles

Idiomas disponibles

SAVE THESE INSTRUCTIONS
CAUTION — PLEASE READ ALL INSTRUCTIONS
CAREFULLY BEFORE OPERATING.
• This product is not intended for medical use. It is intended only to provide a
luxurious massage.
• Consult your doctor prior to using this product, if
- You are pregnant
- You have a pacemaker
- You have any concerns regarding your health
• Not recommended for use by people with diabetes.
Please Note:
• Individuals with pacemakers should consult a doctor before use.
• NEVER leave the appliance unattended, especially if children are present.
For your safety, this
• NEVER cover the appliance when it is in operation.
product is equipped
• DO NOT use this product for more than 15 minutes at a time.
with a pressure
• Extensive use could lead to the product's excessive heating and shorter life.
activated switch
Should this occur, discontinue use and allow the unit to cool before
to control the heat
operating.
function. Heat will
• NEVER use this product directly on swollen or inflamed areas or skin
not operate unless
eruptions.
pressure is applied
• DO NOT use this product before bed. The massage has a stimulating effect
and can delay sleep.
to this switch,
• NEVER use this product while in bed.
located on the back
• This product should NEVER be used by any individual suffering from any
cushion of the unit
physical ailment that would limit the user's capacity to operate the controls.
(see page 7). Once
• This unit should not be used by children without adult supervision.
pressure is removed,
• DO NOT use this product on any wooden surface as it may cause damage.
heat will turn off. After
applying pressure,
Instructions for Use
please allow 5-10
For Use in Home or Office
minutes for heat
Plug adapter into a 120 volt AC outlet and plug the receptacle end into
to reach maximum
the input jack, located in the bottom of the integrated control on the cushion.
temperature.
Attach the massage cushion to any chair for a luxurious massage as you read,
rest or even work.
For Use in Your Car
Simply plug the 12 volt auto adapter into a 12V DC outlet and plug
the receptacle end into the input jack, located along the side of the cushion.
Slip the massage cushion straps over your seat to enjoy a relaxing massage
as you drive.
4
Strapping System
This back massager incorporates a unique strapping system which allows you to
fasten it to most any chair or auto seat. Set the cushion in your seat and adhere the
Please Note:
elastic straps firmly around the seat back. Your massager won't slip or slide around.
Not recommended
for use on wooden
surfaces as the
zipper may
Maintenance
damage the wood.
To Store
Caution is also
Place massager in its box or in a safe, dry, cool place. Avoid contact
with sharp edges or pointed objects which might cut or puncture the fabric surface.
recommended
To avoid breakage, do not wrap the power cord around the unit. Do not hang the
when using on
unit by the controller cord.
upholstered
furniture.
To Clean
Unplug the unit and allow it to cool before cleaning. Clean only with
a soft, slightly damp sponge. Never allow water or any other liquids to come into
contact with the unit.
• Do not immerse in any liquid to clean.
• Never use abrasive cleaners, brushes, gasoline, kerosene, glass/furniture polish,
paint thinner to clean.
• Do not attempt to repair the massager. There are no user serviceable parts. For
Caution:
service, send the unit to the HoMedics address listed in the warranty section.
All servicing of
this massager
Note -
This equipment has been tested and found to comply with the limits for
must be
Class B digital devices, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
performed
residential installation. This equipment generates, uses and can radiate radio
by authorized
frequency energy and, if not installed and used in accordance with the instructions,
HoMedics
may cause harmful interference to radio or television reception, which can be
service
determined by turning the equipment off and on, the user is encouraged to try to
personnel only.
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Note -
The manufacturer is not responsible for any radio or TV interference
caused by unauthorized modifications to this equipment. Such modifications
could void the user authority to operate the equipment.
5

Publicidad

loading