Analyzing a patient's sample (cont'd)
7. Sample type menu
(not for all tests)
Touch Serum or Blood
and confirm the
selection with
Be sure to handle the test cartridge according the instructions on the package insert.
Be sure the test cartridge is properly sealed before you insert it into the analyzer.
Y
Be sure the test cartridge is fully inserted into the proper opening in the analyzer.
Use only test cartridges that are approved by the manufacturer. Otherwise severe damage to the
analyzer and/or incorrect results can occur.
Do not attempt to open or close the panel manually.
_______________________________________________________________________________________
l
Viewing and processing the test results
The Eurolyser laboratory photometer can store up to 100 patient and control results in its memory. When
this capacity is exceeded, the oldest results are deleted in chronological order.
The following parameters are saved from each test:
1. Single result menu
The result is shown.
Touch
to print the
result. Touch
transmit the result to a
PC. Touch
the result. Touch
to close the menu and
end the test.
_______________________________________________________________________________________
SMART quick reference (ED 41208 / revD3 / 20.01.2011)
8. Hematocrit menu
(not for all tests and/or sampletypes)
Enter the hematocrit value and
confirm it with
If you do not enter a value, the
analyser uses a default value of
40.
2. Remove cartridge menu
The analyzer automatically
opens the testing panel.
Remove the test cartridge and
to
discard it. Touch
the panel. The main menu now
to delete
appears. Touch
go to the overall result menu.
9. Start analysis menu
.
3. Overall result menu
Use >> and << to scroll
back and forth within the
menu. Touch
to close
the result(s). Touch
transmit the result(s) to a
PC. Touch
to
result(s). Touch
return to the main menu.
7 / 10
Insert the test cartridge.
Touch
The panel closes
and the analyzer runs the
test automatically.
to print
to delete the
to
Eurolyser Diagnostica GmbH
to