Runpotec CW 800 E Instrucciones De Uso página 12

ENGLISH
12
The cable to be pulled is connected to
the pulling rope – preferably using a con-
necting swivel.
 Switch on the motor and start pulling.
 The operator stands next to the winch, keeping a sufficient safety distance
and pulls the pulling rope, applying very little force, at a 90° angle to the
pulling direction via the safety rope guide.
 The force applied should only be strong enough so as to achieve the
desired feed rate. Pulling with greater force will not increase the capstan
winch's pulling force!
 If the pulling rope slips on the reel, you can counteract this by applying
more force when pulling or by winding on a further 1–2 loops.
Do NOT press the rope onto the pulley by hand! Danger of injury!
 Due to the ideal wrap factor, RUNPOTEC recommends polyester pulling
ropes Ø 10 mm.
INTERFACES FOR HORIZONTAL CABLE PULLING
Cable pulling grip with loop – connection swirl with swivel – pulling rope
All images are representative. Changes and printing errors excepted.
1 m
1 m
Switch the motor on with the
green button and off with the red
button.
Danger area
Working range
WWW.RUNPOTEC.COM