Thermal/Overload Protection - LED's light 190011 Guia De Inicio Rapido

LED's light LED's light
CONTROL CONTROL
important!
It is dangerous if people without proper training
work on an electrical installation.
These should only be carried out by a qualified
electrician.
This dimmer must be protected on the installation
side with a circuit breaker that complies with the
regulations.
Warning : electrocution hazard
There may be a dangerous voltage at the output
of the dimmer!
When working on the wiring always switch off the
mains voltage. Failure to observe this warning
may result in death or serious injury.

Thermal/overload protection

Iintegrated thermal protection circuit. At a dimmer
internal temperature of 120°C
The over-temperature protection is triggered and
remains activated until the temperature drops
down to approximately 90°C. If this happens more
often, please reduce the load.
Note:
Operating at elevated temperatures or voltages
may activate thermal protection.
In this case reduce the connected load to avoid
this again.
Properties:
• Suitable for ON / OFF or AC switching
• Minimum load 5W with capacitive or resistive
load such as dimmable LED lighting, incan-
descent lamps, high-voltage halogen and
low-voltage halogen lamps with electronic
transformer.
Installation manual
Electrical specifications
Parameter
Voltage frequency
maximum load
Dimming
technology
trailing edge
compatible load
operating temperature
Allowed humidity
compatibility
safety standard
compatible
EMC standard compatible
• Soft-start operation to extend the life of
the lamps.
• User setting for the lower brightness value.
• Built-in thermal cut-out to protect the
dimmer at high operating temperature
caused by overload.
• Meets CE and international safety standards.
Values
220-240V ~ 50Hz
HAL/INC:
LED: 5-150W Max.
10-300W Max.
trailing edge
LED
dimmable
Dimmable LED lamps
with compatible
electronic driver
Standard filament
lamps,
High-voltage halogen
lamps
Low-voltage halogen
lamps
with electronics driver
0° - 45°C
10-90% R.H.
suitable for EU switch-mounting
boxes
IEC EN 60669-2-1 : 2013
IEC EN 60669-2-1 : 2002 + A1:
2008 + A2:2015