Detailed Knowledge; When Dirty; I-See Sensor - Mitsubishi Electric MA-E100R-E Manual De Instrucciones

Detailed Knowledge Cleaning
Adjusting the Sensitivity of the PM2.5 Sensor
The sensitivity of the PM2.5 Sensor can be adjusted.
Switch it when the clean monitor is reacting even though the air in the
room is clean.
Switch it when the operation is turned OFF.
l When the PM2.5 Sensor switches to standard sensitivity
The unit makes a "blip" sound and the PM2.5 lamp flashes.
l When the PM2.5 Sensor switches to high sensitivity
The unit makes a "blip blip" sound and the PM2.5 lamp lights up.
* The default sensitivity setting is high sensitivity.
* The settings are stored even when operation is turned OFF and the power
plug is pulled out.
Turning OFF the i-see Sensor and AUTO TURN
Set to OFF when the sound of the AUTO TURN is bothering you or when
you want to clean the air regardless of the position of people.
Set it when the operation is turned OFF.
l When the i-see Sensor and AUTO TURN are switched OFF
The unit makes a "blip" sound and the Dust lamp flashes.
l When the i-see Sensor and AUTO TURN are switched ON
The unit makes a "blip blip" sound and the Dust lamp lights up.
* The default setting is ON.
* The settings are stored even when operation is turned OFF and the power
plug is pulled out.
Changing the orientation of the main unit (AUTO TURN)
The orientation of the main unit (AUTO TURN) can be changed as desired.
Set it when the operation is turned ON.
While pressing continuously, the AUTO TURN rotates.
When the unit has rotated to your preferred position, take your fingers
from the switches.
* After setting the position, the i-see Sensor and AUTO TURN do not operate.
* When operation is turned OFF, the setting is deleted.
14
Press the AUTO
switch 3 times
within 2 seconds
Press the Manual
switch 3 times
within 2 seconds
Press the Manual
switch and the
Auto switch
simultaneously for
3 seconds or more
Perform periodic care and cleaning to maintain the
performance of this unit. Perform care and cleaning
after turning OFF the power switch, pulling out the
power plug, and checking that the blower fan has
stopped.

When Dirty

Main Unit
Wipe with a soft cloth.
When the unit is very dirty, wipe it with a damp
cloth.

i-see Sensor

Gently wipe with a dry
cotton bud.
Do not wipe with water, alcohol, cleaning
agent, etc. This may cause a malfunction.
i-see Sensor