Control Panel - Mitsubishi Electric MA-E100R-E Manual De Instrucciones

Control Panel

l Replace Filter lamp (red)
Lights to notify you when it becomes time to replace
the HEPA filter.
l Clean monitors (orange/red)
The state of air contamination detected with the
odor sensor and PM2.5 Sensor is indicated by
lamps lighting in three steps.
<How to read the clean monitors>
Air is
contaminated
Air is clean
PM2.5 monitor
The state of air contamination from
PM2.5 and other small particles is
detected by the PM2.5 Sensor and then
indicated.
PM2.5 Sensor
This optical sensor detects the
number of particles.
The monitor indications are divided
into "PM2.5" and "Dust" according
to the size of the particles.
* Particles less than 0.5 μm are not
detected.
Adjusting the Sensitivity of
the PM2.5 Sensor P.14
l Operation mode lamps (white)
P.17
Indicate the current operation mode.
l Manual switch
Switches the operation mode
between Low, Middle, and High.
Lit in
red
Lit in
orange
Off
Dust monitor
The state of air contamination from pollen,
dead bodies of mites, and other large
particles is detected by the PM2.5 Sensor
and then indicated.
<Size of dirt particles>
Dust, particles harmful to the lungs
Viruses Feces and dead bodies of mites
Cigarette smoke particles
PM2.5
0.01 0.1 0.5 1 2.5
PM2.5 monitor
Mainly particles of 2.5 μm or less
Mainly particles greater than 1 μm
P.11
P.11
l Operation switch lamps (white)
Lights when the power switch is turned ON.
l Reset button
(The button is located at top right of the unit and
accessible by removing the inlet panel.)
Cancels the Replace Filter lamp.
l i-see Sensor lamp (green/orange)
lLights according to the clean monitors.
(
When clean monitor lamps are lit: Orange
When clean monitor lamps are off: Green
l Flashes in green during the i-see Sensor detection operation.
Pollen
10 100 (μm)
Dust monitor
l Power switch
P.11
Turns ON/OFF the power.
l Auto switch
P.11
Switches the operation mode
between Normal and Night.
P.11
P.17
)
Odor monitor
The state of air contamination
from cigarette odor and other
odors is detected by the odor
sensor and then indicated.
Odor sensor
This semiconducting sensor
detects odors and other gases. It
also responds to wind from air
conditioners, electric fans, and
other appliances, odorless gases,
and perfumes.
9