Operation; Maintaining Water Levels; Emptying The Appliance; Thermal Cut-Out Reset - Buffalo CD582 Manual De Instrucciones

Telephone Helpline: 0845 146 2887 (United Kingdom)

Operation

Thermostat Dial
Connect the appliance to the power supply.
1.
Fill the tank with water to a level between the 'MIN' and 'MAX' marks on the inside of the tank.
2.
Insert the sausage rack into the appliance.
3.
Note: BUFFALO recommend that fresh water be used each time the appliance is used.
Place the lid on the appliance and close.
4.
Switch the power switch to the On position [I]. The power indicator light turns on.
5.
Turn the thermostat to the required temperature.
6.
Once the appliance has heated the water the power indicator light turns Off.
7.
Open the lid and fill the pan with the required amount of sausages.
8.
WARNING: Do not allow the water to drop below the 'MIN' level during operation.
Severe damage to the heating element could result.

Maintaining Water Levels

It is important to regularly check the water level.
• Always keep the water level above the 'MIN' mark on the inside of the tank during operation.
• Damage to the heating element can occur if the tank boils dry and the element may have to be replaced.
• This is not covered by the BUFFALO warranty.

Emptying the Appliance

Note: Always switch the appliance off and allow the water to cool before emptying.
Use a suitable container to remove the water from the appliance.

Thermal Cut-Out Reset

This appliance is fitted with a Thermal Cut-Out safety feature. Should the temperature exceed safe levels
the appliance will automatically cut power.
The Safety Cut-out switch is located on the underside of the appliance, between the back feet. To reset the
appliance after a sufficient cool-down period:.
WARNING: Before resetting the switch ensure the appliance has cooled down and is
empty, as it may need to be tipped slightly to gain access to the switch.
Press the small reset switch down until it clicks, using a blunt pointed instrument.
1.
The appliance is now reset and can be used as normal.
2.
Power Indicator Light
UK
Power Switch
2