Mount To 5 In./6 In. Housing Without Ears - Commercial Electric 53191101 Manual De Uso Y Cuidado

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Mount to 5 in./6 in. Housing with ears (continued)
5
Inserting the spring clips into
the recessed can
□ Compress the spring clips on the LED light module (A)
and insert into the ears on the inside of the recessed can
housing.

Mount to 5 in./6 in. Housing without ears

1
Turning off the power
□ Make sure the power is turned off at the source to
the recessed can housing where the fixture will be
installed. Remove the existing bulb and trim, revealing
the socket.
nOTiCe: Stick the replacement label on
the inner wall of the recessed housing before
installation.
Housing
without
Ears
Spring Clips
A
6
Pushing the LED light module into
the recessed can
□ Carefully push the LED light module (A) into the recessed
can housing until the trim is flush with the ceiling surface.
2
Replacing the spring clips with
friction clips
□ Unscrew the two brackets holding the spring clips
and remove them. Install two friction clips (C)
onto the LED light module (A) using the screws
removed from the spring clip brackets. For a 5 in.
recessed can housing, tighten the screws into the
holes labeled "5" using a Phillips screwdriver (not
included). For a 6 in. can, tighten the screws into the
holes just to the right of "6". For cans up to 6.7 in.,
choose a hole to the left of "6" for best fit.
For 5 in. cans
C
A
6
A
For 6 in. cans
For 6+ in. cans
A
C
A
C

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

1002774081

Tabla de contenido