The Heat Setting; Automatic Heat Up; Power Function; Power Management - Electrolux REX KTI6402XE Manual De Instrucciones

www.electrolux.com
8
• You spill something or put something
on the control panel for more than 10
seconds, (a pan, a cloth, etc.). An
acoustic signal sounds some time and
the appliance deactivates. Remove the
object or clean the control panel.
• The appliance becomes too hot (e.g.
when, a saucepan boils dry). Before
you use the appliance again, wait for
the cooking zone to cool down.
• You use incorrect cookware. The sym-
bol
deactivates automatically after 2 mi-
nutes.
• You do not deactivate a cooking zone
or change the heat setting. After some
time
deactivates. See below.
• The relation between heat setting and
times of the Automatic Switch Off func-
tion:
•
,
•
-
•
-
•

4.3 The heat setting

Touch the control bar at the heat setting.
Move your finger along the control bar to
change the setting. Do not release before
you have a correct heat setting. The dis-
play shows the heat setting.

4.4 Automatic Heat Up

You can get a necessary heat setting in a
shorter time if you activate the Automatic
Heat Up function. This function sets the
highest heat setting for some time (see
the diagram), and then decreases to the
necessary heat setting.
To start the Automatic Heat Up function
for a cooking zone:
1.
Touch
play).
comes on and the cooking zone
comes on and the appliance
- — 6 hours
— 5 hours
— 4 hours
- — 1.5 hours
( comes on in the dis-
2. Immediately touch the necessary heat
setting. After 3 seconds
in the display.
To stop the function change the heat set-
ting.
12
11
10
9
8
7
6
5
4
3
2
1
0
1 2 3 4 5 6 7 8 9 10 11 12 13 14

4.5 Power function

The Power function makes more power
available to the induction cooking zones.
The Power function can be activated for a
limited period of time ( see Technical In-
formation chapter). After that, the induc-
tion cooking zone automatically sets back
to highest heat setting. To activate, touch
, comes on. To deactivate, change
the heat setting.

4.6 Power management

The power management divides the pow-
er between cooking zones (see the illus-
tration). The power function increases the
last selected power to the maximum level
for one cooking zone. The power in other
cooking zones automatically decreases.
The heat setting display for the reduced
zone changes between two levels.
Power limitation function can limit the per-
formance of the appliance.
comes on