Charging The Battery Pack - EarthWise LST02212 Manual De Operador

REPLACING SPOOL / CLEARING JAMS AND TANGLED
LINES
From time to time, especially when cutting thick or stocky
weeds, the line feeding hub may become clogged with sap
or other material and the line will become jammed as a
result. To clear the jam, follow these steps.
- Turn off the trimmer and remove the battery.
- Press the release tabs on the line spool retainer and
remove the cover by pulling it straight off.
- Lift the spool of nylon line out of the hub and clear any
broken line or cutting debris from the spool area.
- In case of jams and tangled line, unwrap about one foot
(30cm) of line to ensure that it is undamaged. If it is OK,
rewind it and insert the line ends through the eyelets in the
spool hub. Pull the line through the hole to maintain tension
while placing the spool down in to the hub with the notched
side exposed.
- Press the spool cover down GENTLY and rotate it until you
feel it drop into place. (When in place, the spool will freely
turn a few degrees left and right.)
- Snap the spool cover back on, insert the battery and turn
the tool on. In a few seconds or less you'll hear the line
being cut automatically to the proper length.
Charger and Battery pack
Constant Red = Battery is charging
Constant Green = Battery is fully
charged.
OPERATING

CHARGING THE BATTERY PACK

SEE CHARGER MANUAL FOR COMPLETE INSTRUCTIONS
Charger
Battery pack
REWINDING SPOOL FROM BULK LINE
(USE ONLY .065" DIAMETER LINE)
Bulk line for your trimmer/edger is available at extra cost
from your local dealer. To install bulk line, follow these steps:

Turn off the trimmer and remove the battery.

Press the release tabs on the line spool cover as shown
in Fig. 1, and remove the cover by pulling it straight off.
Remove the spool from the tool and remove and discard
all line on the spool.

Insert one end of the bulk line into the hole in the spool
as shown in Fig. 2.

Hold the line in the hole and pull the rest of the line
through the slot in the spool as shown in Fig. 3.

Snugly and evenly wind the bulk line onto the spool in
the direction of the arrow until it is nearly full.

Insert the line end through the eyelet in the spool hub
as should in Fig. 4. Pull the line through the hole to
maintain tension while placing the spool down into the
hub with the notched side exposed.

Press the spool down GENTLY and rotate it until you
feel it drop into place. (When in place, the spool will turn
a few degrees left and right freely.)

Snap the spool cover back on, insert the battery and
turn the tool on. In a few seconds you'll hear the nylon
line being cut automatically to the proper length.
INSTALLING AND REMOVING BATTERY PACK FROM
THE UNIT
Slide the battery pack into your tool (see picture). Ensure
the battery is securely connected to tool.
To remove battery, depress release button and slide battery
pack out of tool.
5