Operating Instructions - Kobalt KSL 124B-03 Manual De Instrucciones

OPERATING INSTRUCTIONS

1. To Attach Battery Pack
a. Align the raised portion on the battery pack
with the grooves on the bottom of the tool, then
slide the battery pack onto the tool, as shown.
b. Make sure that the battery-release buttons on
the battery pack snap into place and the battery
pack is secured to the tool before beginning
operation.
NOTICE: When placing the battery pack on the
tool, be sure that the raised rib on the battery pack
aligns with the groove on the tool and the latches
snap into place properly. Improper assembly of
the battery pack can cause damage to internal
components.
To Detach Battery Pack
a. Press the battery-release buttons to release the battery pack.
b. Pull forward on the battery pack to remove it from the tool.
WARNING
• Battery-operated tools are always in operating condition. Be careful when the tool is not in
use or when carrying it at your side.
2. ON/OFF Switch
a. To turn the spotlight ON, press the ON/OFF
switch (D). The spotlight will be turned on at
maximum brightness.
b. To reduce the brightness, press the ON/OFF
switch (D) again.
c. To turn it OFF, press the ON/OFF switch (D)
the third time.
WARNING
• Do not continue to press the ON/OFF switch
after the light has been automatically switched
off. The battery can be damaged.
When the battery capacity is low, the light will blink
cycling from maximum brightness to lower brightness, back to maximum brightness and then
turn off. Charge the battery to avoid battery damage.
Red light mode
Press the ON/OFF switch for about 3 second, light will only illuminate the red light. To exit this
mode, press the ON/OFF switch once, the light will return to previous status.
1
Battery release buttons
2
D
7