HTC HTT-31 Manual Del Operador página 5

5
Using both holes predrilled at the top of
each leg, attach the Long Top Support
Repeat on other side.
6
Using both holes predrilled at the top of each
leg, attach the Short Top Support
Repeat on other side.
7
Using the (8) supplied Wood Screws
and the (8) washers attach the table top.
• Line up predrilled holes in the bottom of
the table tops
in the Short Top Supports
• Be sure the measurements printed on
the table top match up before attaching.
•
longer sides before tightening*
*
If attaching a machine larger than the
table top in closed position, adjust the slats
appropriately before tightening.
8
Insert the Center Shelf Boards as shown.
.
.
and with the slots
.
5