HoMedics AC-100H Manual De Instrucciones página 4

Maintenance
To Store
place cushion in its box or in a safe, dry, cool place. avoid contact with sharp
edges or pointed objects which might cut or puncture the fabric surface. To avoid
breakage, do not wrap the power cord around the unit. do not hang the unit by
the hand control cord.
To Clean
unplug the unit and allow it to cool before cleaning. Spot clean only with a soft,
slightly damp sponge. Never allow water or any other liquids to come into contact
with the unit.
• Do not immerse in any liquid to clean.
• Never use abrasive cleaners, brushes, gasoline, kerosene, glass / furniture
polish or paint thinner to clean.
• Do not attempt to repair the Heated Car Cushion. There are no user service-
able parts. for service, send the unit to the HoMedics address listed in the
warranty section.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Note: The manufacturer is not responsible for any radio or TV interference caused
by unauthorized modifications to this equipment. Such modifications could void the
user authority to operate the equipment.
6
Note: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. if this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
7