Safety; Precautions; Accessories; Front Panel Controls - FTE Maximal SAT 201 B Manual Del Usuario

SAT 201 B

Safety

- Be sure to read the user's manual before starting the operation of the unit.
- Never open the cover. It is very dangerous to touch the inside of the unit due to possible
electric shock.
- When you do not use this unit for a long time, make sure that power cord is pulled out
from the outlet. Also do not use a damaged power cord that may cause fire or electric
shock.
- Do not touch the power cord with wet hand. That may cause electric shock.
- Place the unit in the well ventilated and noheat environment.
If the receiving antenna is not working properly, consult your dealer. Professional installation
is required for a correct direction and angle.
- Earth connection is very important.

Precautions

- Do not install the unit under this conditions: subject to vibrating influence, in excessive
humidity, where temperature is too high or too low, or without ventilation.

Accessories

- 1 Cable
- 2 F bridges (in and out)
- 12 -
BCN
BCN
headend

Front Panel Controls

1. Module powering connectors.
2. 4 digits display
3. PAL and SECAM switch
4. I.F. Bandwidth Selection
5. R.F. Control Mode
6. Channel Control +/-.
7. Control Mode
headend
3
4
5
Let the power come in and out.
It shows the current channel and every position of Control Menu.
To control RF color system: PAL B/G, PAL D/K or SECAM L. Key is operative after
starting function of RF control.
Note: when led shows ( **), mode is SECAM-L, when shows ( **.), is PAL B/G and when ( .**), is
PAL D/K.
To select IF bandwidth for 27 or 36 MHz
Note: when display shows ( ), bandwidth is 27 MHz and when it shows (
Starts function control mode of RF output channel.
To move channel up or down, or to change function VIDEO, AUDIO, C/Ku, H/V, y audio
STEREO/MONO.
To control the functions: VIDEO frequency, AUDIO frequency, C/Ku, H/V, STEREO/
MONO, Audio BW, Audio Deenphasis, Audio Volume, Video level
Attention:
1. ( ) indicates audio stereo, and (
2. When as channel value, appears: (_***), indicates audio stereo; when the channel value
is ( ***), indicates audio mono.
3. In Stereo mode both channels can be tunned separately R indicates Right channel and
L indicates Left channel (ex. R7.02 y L7.20).
- 13 -
SAT 201 B
1
2
6
7
), is 36 MHz.
) indicates audio mono.