MO-EL 726 Guía De Uso Y Mantenimiento página 8

distance between the dryer and the door to avoid hit when opening and
closing the door.
1. Drill 4 holes (diameter 6 mm, depth 35 mm) in the wall according to Fig.
3 and bury the expansion tubes into the holes.
2. Screw out the 2 screws on the right and the left (Fig. 1) and discharge
the shell (Fig. 2).
3. Fix the holder to the wall by means of the 4 fixing screw enclosed with
the appliance; then fasten the shell to the holder; make sure that the air
outlet on the shell and on the holder be fixed each other very well.
4. The power cord can be fixed to the base of the appliance and can pass
through the base itself. The connection diagram is shown in Fig. 4: Pos.
A: Earth wire bicolor; Pos. B: live wire (L); Pos. C: neutral wire (N).
5. Connect the power cord to the electrical supply.
OPERATING
The hand dryer works automatically. After washing your hands, put them
near to the wind hole, located at the bottom. The warm air flows immedi-
ately. As your hands leave the air outlet, the appliance automatically stops,
in order to avoid infection of germs. A safety device causes automatic shut-
down after 60 seconds of continuous use. To short the work time, please
shake the water away from your hands before the use.
TECHNICAL DATA
Power supply
Rated power
Air speed
Detection range
Protection level
Dimensions (cm)
AC 230 V ~ 50 Hz
1800 W
60 m/s
50 ÷ 200 mm
29.5 x 17 x 32.5 (H)
8
IPX1