Door Closing; Remove The Base Grille - Gladiator GABC05FDKG Manual De Uso Y Cuidado

Door Closing (If installing without casters)
Your beverage cooler has four leveling legs. If your beverage
cooler seems unsteady or you want the door to close more easily,
adjust the beverage cooler's tilt using the following instructions.
WARNING
Excessive Weight Hazard
Use two or more people to move and install
beverage center.
Failure to do so can result in back or other injury.
1.

Remove the Base Grille

A. Tabs
Open the beverage cooler door. Using a Phillips screwdriver,
remove the two screws. Push both tabs in toward the center to
release the base grille from the beverage cooler.
Remove the base grille.

Door Closing

Base Grille
B. Screws
1.
Door Closing
Move the beverage cooler into its final location. Turn the leveling
legs to the right to lower the beverage cooler or turn the leveling
legs to the left to raise it. It may take several turns of the leveling
legs to adjust the tilt of the beverage cooler.
NOTE: Having someone push against the top of the beverage
cooler takes some weight off the leveling legs. This makes it
easier to adjust the leveling legs.
Make sure that the door closes as easily as you like. If not, tilt the
beverage cooler slightly more to the rear by turning both front
leveling screws to the left. It may take several more turns, and you
should turn both leveling legs the same amount.
Replace the Base Grille
Open the beverage cooler door.
Position the base grille so that both tabs align and the base grille
snaps into place. Replace the two screws. Tighten the screws.
7