Child Lock; Remote Control - PURIFY F Serie Manual De Usuario

EN

CHILD LOCK

(SERIES F) Touch the key "Child Lock". Upon release, the system will emit
an acoustic signal and enter the selected mode by disabling the detection
of the touch, the remote control and the App. Press the button again, for
about 4 seconds, until the system emits an acoustic signal and deactivates
the child mode.
(SERIES K) Touch the key "Child Lock" to activate the selected mode and
press the button again, for about 5 seconds, until the icon is turned off
(acoustic signal). This mode can also be inserted and removed from the
APP / Remote control by tapping on the appropriate button.
SPEED
With the device on, touch the "Speed" button in the SERIES F or (+/-) in
the SERIES K to increase/decrease the rotation speed of the motor. It is
good to consider that the device will continue to operate at this speed
always ignoring the sensor readings.
SERIES F SERIES K

REMOTE CONTROL

This product is provided with a remote control powered by button cells.
(Please take out the cell if the remote control will not be used for long
periods).
Attention: There is a one-to-one correspondence between the buttons on
the remote control and the operation panel. The functions and operation
methods are generally the same.
Attention: On first use, please take out the cell cover and remove the
protective film of the cell, then replace the cell and its cover.
The remote control must be used pointing it at the IR receiver located on the
front panel of the device no more than 4 meters away. The remote control
has an opening angle of about 60°.
Sunlight or a strongly lit room, or even the presence of obstacles between
the remote control and the IR sensor of the device, can interfere with the
correct operation of the remote control.
09