Replacing The Fuse - Patriot SMT 280 A Manual Del Usuario

Replacing the Fuse

To replace the fuse, follow the steps below. The
location of the fuse holder.
1
Switch off the Patriot unit and all of the load equipment. Unplug the Patriot unit and the
load equipment. Disconnect the line cord from the back of the unit.
2
The top of the fuse holder has a small notch. Place a screwdriver into this notch and
gently pry the fuse holder out of the unit.
3
One spare fuse is provided in the fuse holder. If the spare
fuse has been used, call Best Power to order a new fuse.
The new fuse must be the size and type listed on the
label below the fuse holder.
4
Push the spare fuse out of the fuse holder.
5
Remove the old fuse and put the new fuse in its place. Then, push the fuse holder back
into the unit until it clicks into place.
6
Reconnect the line cord to the back of the unit. Plug the load equipment back into the
unit. Plug the unit into the wall outlet. Switch on the unit.
7
Before switching on the load equipment, let the Patriot unit run for five minutes.
Make sure that the green LED stays lit.
! If the fuse blows again (the green LED goes off and the yellow LED comes on), call
your local Best Power office.
! If the unit runs on line (the green LED stays lit) for five minutes, the original fuse
may have blown due to an overload of equipment on the unit. You may need to
reduce the amount of load equipment.
8
Switch on the load equipment one piece at a time.
ENGLISH
back panel drawings
6
on page 3 show the
Fuse
Spare Fuse