Using Your Accessories - Sencor SVC 7CA-NAA1-09 Manual Del Usuario

SVC 7CA-NAA1-09 / SVC 7CA-NAA1-10 /SVC 7CA-NAA1-11 / SVC 7XX-NAA1-YY
Switching your vacuum cleaner on and off
To switch your machine on or off, press the START / STOP button on the vacuum cleaner body.
Adjusting the suction strength
The suction strength may be adjusted by moving the rider on the vacuum cleaner body (small range) or by the
movable rider on the hose handler.
Tips
• Use the maximum suction strength when vacuuming carpets or fl oors with a hard surface. Use the
reduced strength when vacuuming upholstery, window curtains, etc.
• If the hose holder becomes blocked when vacuuming, disconnect it from the telescopic tube and also
disconnect the hose from the vacuum cleaner body. Then place the holder inside the suction hole on
the vacuum cleaner body and vacuum the stuck dirt out.
Temporary interruption of the vacuuming process
If you want to stop vacuuming for a short time, you may use one of the parking positions:
• for the horizontal parking position, use the stopper at the end of the fl oor nozzle,
• for the vertical parking position use, the stopper on the telescopic tube.
Note:
Do not move the vacuum cleaner from place to place if the hose is in the parked position! It may break off
or the lugs for the fl oor nozzle or telescopic tube may break off.

USING YOUR ACCESSORIES

D
1 Slot nozzle for vacuuming
in hard to reach places (e.g.
windows, corners, book
shelves, areas between
mattresses, upholstery, etc.)
2 Upholstery nozzle
3 Brush nozzle (by turning the
brush part, you can use it
for vacuuming hard to reach
places)
Tip:
If during vacuuming, you use an accessory very often, you may attach it to the special holder on the
telescopic tube.
Copyright © 2014, Fast ČR, a.s.
Vacuum cleaner
1
3
EN-6
2
Revision 10/2014