Storing The Vacuum Cleaner; Cleaning And Maintenance - Sencor SVC 7CA-NAA1-09 Manual Del Usuario

SVC 7CA-NAA1-09 / SVC 7CA-NAA1-10 /SVC 7CA-NAA1-11 / SVC 7XX-NAA1-YY
Ending the vacuuming process
When you fi nish vacuuming, switch the vacuum cleaner off by pressing the START / STOP button and then
disconnect the power plug from the socket.
To wind the power cord back to the vacuum cleaner, press and hold the winding button with one hand. Hold the
cord with your other hand to protect the vacuum cleaner input area from damage.
Tip:
If the winding process stops and part of the power cord is still outside, release the winding button and pull
the cord out again by about 50 cm and press the winding button again and repeat the winding process.
Carrying your vacuum cleaner
It is possible to hold and carry the vacuum by the handle.

STORING THE VACUUM CLEANER

Before storage, you can disassemble your product to each individual part or you can store it assembled with the
telescopic tube stored in one of the parking positions.

CLEANING AND MAINTENANCE

Caution:
Before cleaning, disconnect this product from the power source.
Changing the dust bag
Replace the dust bag as soon as the full dust bag warning light comes on; otherwise, the air fl ow and the suction
strength will be reduced.
E
1
2
1 Lid clip
2 Dust bag collar
3 Dust bag
Copyright © 2014, Fast ČR, a.s.
Vacuum cleaner
4
3
4 Dust bag holder
EN-7
Revision 10/2014